Clean Energy SF: San Francisco, fog then sun, est. 2026

Vol. 1 - No. 14 - Thursday, September 24, 2026 - Free to readers

Grid ยท Analysis

Caltrain goes electric: the new wire over the Peninsula

Electric trainsets now run most of the San Francisco to San Jose line, drawing from a single overhead wire and feeding power back when they brake. Here is where that energy comes from and what the roadside substations do.

I. Where the wire gets its power

If you have waited at 4th and King in San Francisco in the past couple of years, you have likely noticed the trains got quieter and quicker off the mark. The diesel growl is mostly gone from the Peninsula's busiest line, replaced by double-deck electric trainsets that began carrying passengers in the second half of 2024, per Caltrain's own project updates. Overhead runs a single new wire, a 25,000-volt alternating-current catenary (the tensioned line a train's roof arm slides along to collect power), strung the length of the San Francisco to San Jose corridor.

That wire does not generate anything. It is fed from the regular power grid through a handful of trackside buildings called traction power substations, which step high-voltage transmission down to the level the trains use. The electricity reaching them comes through PG&E transmission, so the mix behind your train on any given afternoon is whatever the California Independent System Operator (CAISO, the nonprofit that runs the state's grid) happens to be dispatching that hour: a blend of solar, gas, hydro, imports, and more depending on the season and time of day.

II. The trains that push power back

The part that surprises people is braking. When one of these electric trainsets slows into a station, its motors run in reverse and act as generators, a trick called regenerative braking. Instead of burning off all that motion as heat in friction brakes, the train turns some of it back into electricity and pushes it up into the catenary, where a nearby train that is accelerating can draw it down and use it.

How much gets recovered depends on timing and traffic. If no other train is pulling power at that moment, some of the energy has nowhere to go and is lost. On a busy corridor with trains spaced through the day, though, the honest expectation is real savings on net traction energy compared with diesel, which recovers none of this. Caltrain and the manufacturer have described regenerative braking as a core efficiency of the fleet, and it is the kind of thing you can watch for in future energy-use reports rather than take on faith today.

III. What the roadside substations actually do

Spread along the right of way is a small chain of electrical buildings, roughly two main traction power substations plus a set of smaller switching and paralleling stations, per Caltrain's design materials. The main substations are the connection points to the grid; they take transmission-level power and convert it to the 25 kV single-phase supply the catenary needs. The smaller stations keep voltage steady along the miles of wire and tie the two tracks' power together so trains share supply.

For a rider in Burlingame or Redwood City, these look like fenced gray boxes with insulators on top, easy to miss. Their job is boring in the best way: hold the wire at a usable voltage whether one train or six are on the line, and open the circuit fast if something faults. Because railway load is small next to a whole region's demand, you will not see Caltrain move the needle on a CAISO chart, but the substations are where the railroad and the grid actually touch.

IV. Worth watching this month

1. Caltrain's monthly ridership and on-time performance reports, usually attached to the board meeting agenda at caltrain.com, for whether the faster electric schedule keeps holding its numbers (routine, but the clearest public signal).

2. Any Caltrain update on extending electric service, since some diesel trains still run south of San Jose toward Gilroy at last public report, and plans there can shift.

3. CAISO's public demand and supply dashboard on an average weekday, worth a look mainly to see how small rail load is against the regional total (routine context, not news).

4. Progress on The Portal, the downtown San Francisco rail extension that would eventually bring these electric trains past 4th and King, where schedules have slipped before and are worth checking rather than assuming.

Frequently asked questions

Is the whole line electric now?

Most of the San Francisco to San Jose segment runs on electric trainsets. Some diesel service continued south of San Jose toward Gilroy at last public report, so not every Caltrain train is electric yet.

Does regenerative braking really cut energy use?

In principle yes, because a braking train returns power to the wire instead of wasting it as heat. The real-world savings depend on whether another train is nearby to use that power at the same moment, so the honest answer is that it helps on a busy schedule and helps less on an empty one.

Where does the electricity actually come from?

From the regional grid, reaching the trackside substations through PG&E transmission. That means the generation mix behind your train is whatever CAISO is running that hour, which changes with the season and time of day.

Is electric Caltrain cleaner than the old diesels?

At the trackside there is no tailpipe exhaust, which is a clear local air-quality gain for neighborhoods along the line. Whether it is cleaner overall depends on the grid mix at the time, but California's mix is generally cleaner than burning diesel on board.

References