Grid ยท Analysis
The power a braking BART train throws away, and the battery meant to catch it
When a BART train brakes, it briefly becomes a generator. A trackside battery BART has tested aims to catch that power before it burns off as heat.
I. What the brakes throw away
Regenerative braking (letting the motors act as generators to slow the train) is not new, and BART trains already do it. The catch is timing. The third rail is a shared wire, so a braking train can only return power if something else on that stretch is ready to take it in the same few seconds. Headways on a given line, the gaps between trains, decide how often that lucky overlap happens.
When the overlap does not happen, the surplus goes to resistor banks that turn it into heat, which is wasted twice over, once as lost energy and again as warmth that tunnels and stations then have to shed. A trackside battery changes the math by giving the power a place to wait. It stores the braking surge for the seconds or minutes until the next train leaves a nearby platform, then releases it, so the substation pulls less fresh power from the utility.
II. The honest math
How much this saves is exactly the kind of number worth being careful with. Savings depend on how crowded the line is, how steep the grade, and how often two trains are braking and accelerating within reach of each other. A battery on a busy downtown segment with trains every few minutes will earn its keep far faster than one on a quiet outer stretch.
BART and its funders have described the effort as a pilot, not a system-wide rollout, which is the right frame to keep. Treat any single percentage you see for energy recovered as a figure from one site under one set of conditions, not a promise for the whole network. The useful test is whether the recovered energy, plus the value of a smoother load on the grid, pays back the cost of the battery over its life, and that answer is still being measured.
III. Who is behind it, and why San Francisco cares
The players are few and public. BART runs the trains and the traction power. The California Energy Commission, the state agency that funds energy research and sets appliance and building efficiency standards, has backed the storage work. The grid beyond the third rail is run for most of California by the California Independent System Operator, the nonprofit that balances supply and demand across the state's high-voltage lines.
For a city buying more of its power through CleanPowerSF, the SFPUC program that supplies many San Francisco households with a greener electricity mix, a transit agency that draws less and more evenly is a small gift. Smoother demand is easier and cheaper to serve than sharp peaks. None of this shows up on your home bill directly, but a large public rider of the grid using less is the kind of change that, repeated enough, keeps everyone's costs steadier.
IV. Worth watching this month
1. Watch for BART board or committee agendas that mention wayside energy storage or traction power, where any results from the pilot would surface first.
2. Keep an eye on the California Energy Commission's public pages for updates on the grant that funded the work, which is where a results report would be posted.
3. Note whether BART folds energy storage into its larger sustainability or rail-car power planning documents, a routine sign the idea is moving past a one-off test.
4. Watch CAISO notices for how the grid is handling winter evening peaks, the hours when any load the transit system can shave matters most.
5. Treat early figures as provisional, and check whether the agency publishes a full accounting before trusting a headline savings number.
Frequently asked questions
Does my BART fare or electric bill change because of this?
Not directly. The savings land on BART's own power costs and on the grid's load, not on your fare or your home electricity bill. The benefit to riders and ratepayers is indirect, through steadier costs over time.
Don't the trains already recover braking energy?
Yes, in part. BART trains already feed power back to the third rail when braking, but only another nearby train can use it right then. The battery captures what would otherwise be burned off as heat when no train is ready to take it.
Is this the same as the battery in an electric car?
The chemistry is similar, but the job is different. A car battery stores energy for hours of driving, while a wayside battery cycles quickly, catching surges that last seconds and releasing them minutes later. That fast, frequent cycling is the hard part.
Will BART put these along every line?
That is not decided. The current work is a pilot at a limited number of sites. Whether it spreads depends on what the measured savings turn out to be and how the costs compare over the battery's life.
References
- BART, Sustainability (bart.gov, transit agency and .gov), The agency's own pages on energy use and sustainability goals, where pilot results and planning documents would appear., www.bart.gov/about/sustainability.
- California Energy Commission (energy.ca.gov, state agency and .gov), The state body that funds energy research grants; the place to look for updates on the funding behind the storage work., www.energy.ca.gov.
- California ISO (caiso.com, state grid operator), The operator that balances California's high-voltage grid, with notices on demand, peaks, and how large loads affect the system., www.caiso.com.
- CleanPowerSF (cleanpowersf.org, SFPUC program page), The SFPUC program supplying many San Francisco homes a greener power mix, useful for how local electricity is sourced., www.cleanpowersf.org.
- California Public Utilities Commission (cpuc.ca.gov, state regulator and .gov), The regulator overseeing utility rates and grid policy, for context on how load and cost decisions get made., www.cpuc.ca.gov.